Skip to content

Chevy cruze 2019 oil change

🧰 2019 Chevy Cruze Oil Change Guide (Full Synthetic 0W-20 + M1-113A Filter)

Changing the oil in your 2019 Chevy Cruze is essential for maintaining engine performance and longevity. This guide outlines the necessary tools, parts, and step-by-step instructions for a clean and efficient oil change using full synthetic 0W-20 oil and a Mobil 1 Extended Performance M1-113A oil filter.


🛒 Parts & Supplies Needed

Item Specification Notes
Motor Oil 0W-20 Full Synthetic 4.2–4.5 quarts with filter
Oil Filter Mobil 1 M1-113A Extended performance, 20k miles
Oil Filter Wrench Cap-style wrench for M1-113A ~74mm 14-flute cap usually fits
Socket/Wrench 15mm socket For drain plug removal
Drain Pan At least 5-quart capacity To collect old oil
Funnel Medium or wide-mouth For pouring oil cleanly
Gloves & Rags Nitrile gloves, shop towels For safety and cleanup

🛠️ Steps for Changing the Oil

  1. Warm Up Engine (Optional) Let the engine run for 5 minutes to warm the oil. This helps drain it more completely.

  2. Lift Vehicle (If Needed) Use ramps or jack stands to access the drain plug underneath.

  3. Drain Old Oil

  4. Place the drain pan under the oil pan.

  5. Use a 15mm socket to remove the drain plug.
  6. Allow all oil to drain completely (5–10 minutes).
  7. Reinstall the drain plug and torque it to 18 lb-ft (24 Nm).

  8. Remove Old Oil Filter

  9. Use the filter wrench to loosen the M1-113A filter.

  10. Let excess oil drain from the filter mount.
  11. Wipe the filter mounting area clean.

  12. Install New Oil Filter

  13. Lightly oil the rubber gasket of the new M1-113A filter.

  14. Screw on the filter by hand until the gasket contacts the base, then tighten ¾ turn more.

  15. Add New Oil

  16. Use a funnel to pour in 4.2 quarts of 0W-20 full synthetic oil.

  17. Check the dipstick; top up to max if needed.

  18. Start Engine & Check

  19. Let the engine run for 30 seconds.

  20. Check under the vehicle for leaks.
  21. Shut off engine, wait 2 minutes, recheck oil level.

  22. Reset Oil Life Monitor

  23. On the dash, navigate to “Oil Life”.

  24. Hold down the “Check” or “Set/Reset” button until it resets to 100%.

🔁 Maintenance Tip

Mobil 1 M1-113A is rated for up to 20,000 miles but follow Chevy’s maintenance schedule and adjust for driving conditions. Typically, change oil every 7,500–10,000 miles or annually.


🔧 Torque Specs Summary

Component Spec
Oil Drain Plug 18 lb-ft (24 Nm)
Oil Filter (Hand Tightened) ¾ turn after gasket contact

🗑️ Disposal

Take your used oil and filter to your local auto parts store or recycling center. Do not dump it in the trash or down the drain.


✅ Summary

  • Oil Type: 0W-20 Full Synthetic
  • Oil Capacity: 4.2 to 4.5 quarts with filter
  • Oil Filter: Mobil 1 M1-113A
  • Drain Plug Socket: 15mm
  • Torque: 18 lb-ft